Honda XR100 License Plate Mount Installation Instructions

Required Tools: Drill with 1/8” and 1/4” drill bit, ratchet with 10mm socket, 4mm allen key, permanent marker.

Warning! Sharp tools are used in this installation. Take proper precautions to prevent injury!

  1. If no offroad plate or mount is currently installed, place the 3DC License Plate Bracket into position under the rear fender.
  2. Align the narrow part of the mount as straight as you can and mark the holes with the permanent marker.
  3. Using a 1/8” drill bit, pilot drill the four holes. If not centered, move to a slightly larger bit and correct the hole to the center of the mark.
  4. Using the 10mm socket and the 4mm Allen key, install the provided hardware to mount the plate bracket on the fender.
  5. Install your offroad license plate.
  6. Go get dirty!

FIG. 1

FIG. 2

FIG. 3

FIG. 4

Share this:

Like this:

Like Loading...