KTM On/Offroad License Plate Mount Installation Instructions
Required Tools: Drill with 1/8” and 1/4” drill bit, ratchet with 10mm socket, 4mm allen key, side cutters, permanent marker.
Warning! Sharp tools are used in this installation. Take proper precautions to prevent injury!
Remove old license plate and mount.
Place the 3DC License Plate Bracket into position on the rear fender.
Using a 1/8” drill bit, pilot drill the three holes. If not centered, move to a slightly larger bit and correct the hole to the center of the mark.
Using the 10mm socket and the 4mm Allen key, install the provided hardware to mount the plate bracket on the fender.
The On-road installation will require you to snip off the towers that the stock screws mounted to. This will allow you to thread the nut onto the provided bolt.
