Yamaha Fork Guard Installation Instructions

Required Tools: 10mm socket, 5mm allen socket and ratchet, inch pounds torque wrench Caution! Torque is 170 inch pounds. Over torque can crack the part.

  1. Perform these steps one fork at a time.
  2. Using a 10mm socket, remove the lower fork axle clamp hardware.
  3. Install the correct guard for the side you are working on with the supplied hardware and a 5mm allen socket. Snug the screws by hand.
  4. Torque both allen head screws 85 inch pounds. Then torque both to 170 inch pounds.
  5. Go get dirty!

Prior to installation


WR Installed Part



Share this:

Like this:

Like Loading...